Panasonic kx-tcd820e Manual De Usuario

–

 4 

–

5

What kind of power outlet 
should I connect the AC 
adaptor to?

Connect the AC adaptor to a 220–240 V outlet. 

Why is w flashing?

L

The handset is too far from the base unit. Move closer.

L

The AC adaptor is not connected. Check the 
connections.

L

The handset is not registered to the base unit. Register it.

"

 (centre of joystick) i m i # i 

“Registration” i # i “Register H.set” i 
#

 i Select a base unit number. i # i Press 

and hold {x} on the base unit for about 3 seconds, until the 
registration tone sounds. i Wait until “Enter Base 
PIN” is displayed. i Enter the base unit PIN (default: 
“0000”). i #

Why is the handset display 
blank?

The handset is not turned on. To turn the power on, press 
{ih}

 until a short beep sounds.

What should I do when the 
handset does not turn on?

L

Make sure that the batteries are installed correctly. 

L

Fully charge the batteries.

L

Clean the charge contacts and charge again.

How long should I charge new 
batteries?

Charge the batteries for about 7 hours.

How long is the battery 
operating time? 

When you are using fully-charged Ni-MH batteries;
Talking: 14 hours max.
Standby: 150 hours max.

L

Battery operating time may be shortened over time 
depending on usage conditions and ambient 
temperature.

When should I replace the 
batteries?

If the batteries are fully charged until ! is displayed, but # 
is displayed after a few calls, replace the batteries with new 
ones.

What is a PIN?

The PIN is a 4-digit number that must be entered in order 
to change certain handset and base unit settings. The 
default PIN for both the handset and base unit is “0000”.

What do I need to do to 
display caller information?

You need to subscribe to Caller ID service. Consult your 
service provider for details.

TCD820E_QG(e).fm  Page 4  Wednesday, July 13, 2005  5:40 PM

Black process 45.0° 60.0 LPI