Panasonic th37pa60e Manual De Usuario
FAQs, etc.
30
31
Licence
Trademark Credits
•
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of
HDMI Licensing LLC.
FAQs
Specifications
Note
•
Design and Specifications are subject to change without notice. Weight and Dimensions shown are approximate.
•
This equipment complies with the EMC standards listed below.
EN55013, EN61000-3-2, EN61000-3-3, EN55020.
TH-37PA60E
TH-42PA60E
Power Source
AC 220-240 V, 50 / 60 Hz
Power
Consumption
Average use
206 W
238 W
Standby condition
0.3 W
Plasma Display
panel
Drive method
AC type
Aspect Ratio
16:9
Contrast Ratio
Max 10000:1
Visible screen size
(No. of pixels)
94 cmV
106 cmV
818 mm (W) × 461 mm (H) ×
939 mm (diagonal)
920 mm (W) × 518 mm (H) ×
1,056 mm (diagonal)
408,960 (852 (W) × 480 (H)) [2,556 × 480 dots]
Sound
Speaker
12 cm × 6 cm × 2 pcs, 8 Ω
Audio Output
20 W (10 W + 10 W), 10% THD
Receiving Systems /
Band name
PAL B, G, H, I, SECAM B, G, SECAM L / L’
VHF E2 - E12
VHF H1 - H2 (ITALY)
VHF A - H (ITALY)
UHF E21 - E69
CATV (S01 - S05)
CATV S1 - S10 (M1 - M10)
CATV S11 - S20 (U1 - U10)
CATV S21 - S41 (Hyperband)
PAL D, K, SECAM D, K
VHF R1 - R2
VHF R3 - R5
VHF R6 - R12
UHF E21 - E69
PAL 525/60
Playback of NTSC tape from some PAL Video recorders (VCR)
M.NTSC
Playback from M. NTSC Video recorders (VCR)
NTSC (AV input only) Playback from NTSC Video recorders (VCR)
Aerial - Rear
VHF / UHF
Operating Conditions
Temperature : 0 °C - 40 °C
Humidity
: 20 % - 80 % RH (non-condensing)
Connection T
erminals
AV1 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in)
AV2 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, S-Video in, Q-Link)
AV3 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, S-Video in, Q-Link)
Others
COMPONENT Y
1.0 V[p-p] (including synchronization)
P
B
, P
R
±0.35 V[p-p]
HDMI
TYPE A Connector
AUDIO L - R
RCA PIN Type × 2
0.5 V[rms]
Output AUDIO L - R
RCA PIN Type × 2
0.5 V[rms] (high impedance)
Dimensions ( W × H × D )
968 mm × 641 mm × 97 mm (TV Set only)
968 mm × 704 mm × 320 mm (With Pedestal)
1,068 mm × 701 mm × 97 mm (TV Set only)
1,068 mm × 764 mm × 320 mm (With Pedestal)
Weight
25.0 k Net (TV Set only)
27.0 k Net (With Pedestal)
29.0 k Net (TV Set only)
31.0 k Net (With Pedestal)
•
Licence / Specifi
cations
•
Frequently
Asked Questions
Problem
Actions
Screen
Sound
Other
HDMI
Chaotic image, noisy
•
Set "P-NR" in the Picture menu (to remove noise).
(p. 14)
•
Check nearby electrical products
(car, motorcycle, fluorescent lamp).
Blurry or
distorted image
(no sound or low volume)
•
Reset channels. (p. 18)
No image can be
displayed
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 14)
Neither image nor
sound is produced
•
Is the unit in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV unit turned On?
•
Check Picture menu (p. 14) and volume.
No sound is produced
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
Sound is unusual
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI input" setting in the Sound menu.
(p. 14)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 27)
Sound level is low
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 14) in the Sound menu to "Mono".
TV unit goes into
"Standby mode"
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
An error message
appears
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
An error message
appears
•
Contact the authorized Service Centre.
"Control with HDMI"
function does not work
•
Switch the TV unit on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again.
(p. 21)