Panasonic vb43050 Manual De Usuario

Appendix A. EX 1.0 Feature Update

Section 700-Operation

Page A-34

DBS Manual - Revised April 2000

DBS-2.3/9.2-700

• FF1 (System): SMDR Print 

• FF1 (System): Parity Check

• FF1 (System): Odd/Even Parity

• FF1 (System): Baud Rate

• FF1 (System): Stop Bit Length

• FF1 (System): Data Length

• FF1 (System): Serial Port Flow Control (X On/ X Off)

• FF1 (System): SMDR Display Start Timer for CO Calls

• FF1 (System): SMDR Printing Mode 1: Outbound, Inbound, Network

• FF1 (System): SMDR Printing Mode 2: Long Distance and Local Calls

• FF1 (System): SMDR Printing Mode 3: Header Title

• FF3 (Extension) Station Message Detail Recorder (SMDR) Report

• A printer or external call accounting system is required to receive SMDR 

data.

• Unlike other CPC circuit cards, the CPC-EX supports two serial ports. 

Serial Port 1 is labeled CN4 and is located on the backplane. Serial Port 2 
is labeled CN5 and is located on the front of the CPC-EX card. Serial Port 
2 requires a special interface cable.

• Be sure to select the correct port to output SMDR data. From the 

Attendant’s phone:

-  

dial 

#90 to set Serial Port 1 (the backplane port) to output Bus 

Monitor/Maintenance and Serial Port 2 to no output. 

- dial 

#92 to set Serial Port 1 to output SMDR and Serial Port 2 

to output Bus Monitor/Maintenance data. 

- dial 

#93 to set Serial Port 1 to output SMDR data and Serial 

Port 2 to no output.