honda-automobiles 2008 civic sedan Manual De Usuario
Remove the oil filter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
remaining oil drain. A special
wrench (available from your
dealer) is required.
Refill the engine with the
recommended oil.
Engine oil change capacity
(including filter):
recommended oil.
Engine oil change capacity
(including filter):
Replace the engine oil fill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine, and check your work.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn off the
engine, and check your work.
Let the engine run for several
minutes, then check the drain bolt
and oil filter for leaks.
minutes, then check the drain bolt
and oil filter for leaks.
Install a new oil filter according to
the instructions that come with it.
the instructions that come with it.
Make sure to clean off any dirt
and dust on the connecting
surface of a new oil filter.
and dust on the connecting
surface of a new oil filter.
Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to:
then reinstall the drain bolt.
Tighten the drain bolt to:
Make sure the oil filter gasket is
not stuck to the engine block. If it
is, remove it before installing a
new oil filter.
not stuck to the engine block. If it
is, remove it before installing a
new oil filter.
5.
6.
7.
8.
3.
4.
Except Si
Si
CONTINUED
Changing the Engine Oil and Filter
Ma
int
e
e
na
nce
nce
235
OIL FILTER
Except Si
Si
3.9 US qt (3.7 )
29 lbf·ft (39 N·m , 4.0 kgf·m)
4.6 US qt (4.4 )
07/07/03 21:13:38 31SNA620 0240