Compaq proliant ml350 Manual De Usuario

  

 

 

CAUTION:  To prevent damage to equipment or loss of information, make sure that the server 
is powered down, all cables are disconnected from the back of the server, and the power cord 
is disconnected from the grounded (earthed) AC outlet before removing the access panel. 

 

 

CAUTION:  To prevent damage to the system when handling components, refer to the 
Compaq ProLiant ML350 Generation 3 Server Setup and Installation Guide.  

 

 

CAUTION:  When handling a memory module, be careful not to touch any of the contacts. 
Doing so may damage the module. 

 

The following guidelines must be followed when memory modules are being added or 
replaced: 

•  DIMMs must be industry-standard, 128-MB, 256-MB, 512-MB, 1-GB or 2-GB, 

3-cm (1.2-inch), 184-pin PC2100, DDR ECC memory DIMMs. The DDR memory 
DIMMs must support CAS Latency 2, CL=2 or greater. They must also contain the 
mandatory Joint Electronic Device Engineering Council (JEDEC) Serial Presence Detect 
(SPD) information. 

•  If two-way memory interleaving is desired, identical DIMMs must be installed in socket 

pairs. DIMMs installed in Pair A (sockets 1 and 2), however do not need to be identical 
to the DIMMs in pair B (sockets 3 and 4). If the two DIMMs within a pair are not 
identical, the system will automatically run in non-interleaved mode. 

•  DIMMs installed in the server must be registered DDR, 3.3-volts, 72-bits wide.