Gateway 7210 Manual De Usuario

          Replacing and Adding Internal Devices

You can use the three additional, externally accessible 5.25-inch drive bays 
to install additional 5.25-inch devices such as a CD writer or a tape backup 
drive. Use the rails from the existing filler trays to install new drives. You may 
need to purchase an additional cable of sufficient length to connect the 
existing devices and the new device to the connector on the system board.

Turn off the system and disconnect the power cord and all other external 
peripheral devices.

Open the case. (See “Opening the case” on page 23 and “Preventing static 
electricity discharge” on page 22.)

Remove the filler tray from the front of the drive bay, by pressing in on 
both front rail extensions, then move the tray slightly out of the bay by 
pushing on the back of the tray.

Snap the rails onto the drive, making sure the front rail extensions are 
towards the front of the device. The rails are labeled.

Align the rails with the bay, and slide the drive into the chassis until the 
locking tabs snap into place.

The server was designed to adhere to electromagnetic 
interference requirements and the tray is an integral part 
of the system. Installing an approved device should 
continue to maintain those standards. If you remove the 
device you must reinstall the tray.

8505945.book  Page 48  Thursday, March 9, 2000  2:13 PM