Gateway 860 Manual De Usuario

Troubleshooting steps

www.gateway.com

■

Make sure that the power button on the front panel is turned on.

■

Make sure that the power cable is connected correctly.

■

Turn off the NAS by pressing the power button, then restart the NAS. 
During the startup procedure, the NAS checks the file system. The length 
of this check varies depending on the amount of data on the NAS (in some 
extreme cases, it can take as long as two hours). 

■

Make sure that the network cable is connected correctly.

■

Make sure that the LINK LED and ACT LED are lit.

■

Make sure that the IP address entered on the browser is correct. 

■

Make sure that no other networked device is using the same IP address as 
the NAS. 

■

Make sure that the network cable is not damaged.

■

Make sure that there is no problem with the connection between the 
network hub and the computer, NAS, or hub connectors.

■

Make sure that you are using the correct type of disc.

■

Make sure the CD is correctly inserted in the drive.

■

Make sure that the CD is clean and is not scratched.

■

Make sure that the cables for the new peripheral are firmly connected and 
that the pins are not bent.

■

See the documentation that came with the new peripheral to see if any 
device drivers need to be installed.

■

Make sure that the network status indicator lights up.

■

Check the cabling and network equipment for the correct connection.

■

Reinstall the network drivers.