Gateway E-824R Manual De Usuario
Features
www.gateway.com
3
Gateway E-826R LTO-3 SuperLoader 3
The Gateway E-826R LTO-3 SuperLoader 3 is SCSI-3 compatible and operates as
a single SCSI ID/two LUN data storage device. It is equipped with an LTO-3 tape
drive and contains as many as sixteen Ultrium 3 data cartridges, when using two
magazines, which provides a compressed capacity of 6.4 Terabytes of data and
a sustained data transfer rate of 245 GB per hour (native), or as high as 490 GB
per hour compressed (assuming 2:1 compression).
a single SCSI ID/two LUN data storage device. It is equipped with an LTO-3 tape
drive and contains as many as sixteen Ultrium 3 data cartridges, when using two
magazines, which provides a compressed capacity of 6.4 Terabytes of data and
a sustained data transfer rate of 245 GB per hour (native), or as high as 490 GB
per hour compressed (assuming 2:1 compression).
Bar code reader
A bar code reader is enclosed within the body of the autoloader. The bar code
reader automatically scans each cartridge in the magazine when the power is
turned on, after a reset, after an import or export, or when a re-inventory
command is issued (see
reader automatically scans each cartridge in the magazine when the power is
turned on, after a reset, after an import or export, or when a re-inventory
command is issued (see
). Other than that,
there is no user interface with the bar code reader through the front panel
operator controls or LCD screen. The information from each label is stored in
memory and is available through SCSI and On-board Remote Management to
the computer's operating system or backup application upon request.
operator controls or LCD screen. The information from each label is stored in
memory and is available through SCSI and On-board Remote Management to
the computer's operating system or backup application upon request.
If you use the bar code reader, you must apply or slide the bar code labels into
the appropriate slot on the right side of each cartridge. The labels must conform
to ANSI/AIM BC1 -1995 Uniform Symbology Specification Code 39. A set of bar
code labels is included with the autoloader.
the appropriate slot on the right side of each cartridge. The labels must conform
to ANSI/AIM BC1 -1995 Uniform Symbology Specification Code 39. A set of bar
code labels is included with the autoloader.
Accessories
The following accessories are shipped with the autoloader:
■
SCSI host cable
■
SCSI terminator
■
Hardware to rack mount the autoloader
■
T8 and T10 TORX
®
L-Key drivers
■
One magazine blank
■
Power cable
■
Documentation CD containing all of the documentation
■
Bar code labels