JVC SP-UXP550 Manual De Usuario

 

• If the AM loop antenna wire or speaker cords are covered 

with vinyl, remove the vinyl to expose the tip of the 
antenna by twisting the vinyl.

• Make sure the antenna conductors do not touch any other 

terminals, connecting cords and power cord. Also, keep the 
antennas away from metallic parts of the System, 
connecting cords, and the AC power cord. This could cause 
poor reception.

 

Connect the right speaker to the RIGHT terminals, and the 
left speaker to the LEFT terminals.

When connecting the speaker cords, match the polarity of 
the speaker terminals:
• For LOW terminals: Red cord to (+) and black cord to (–).
• For HIGH terminals: Grey cord to (+) and blue cord to (–).

 

When connecting a TV, you can use either one of the video 
output terminals—COMPONENT or AV OUT.
After connecting the TV, set the video signal type correctly 
for your TV.
• Make sure the unit is not yet turned on. If it is already 

turned on, turn off then on again so that the selector setting 
becomes active.

 

This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT 
jacks, you can enjoy a high quality picture from the built-in 
DVD player by selecting “PROGRE.”
• If the VIDEO OUT SELECT switch is not set to “Y/C,” 

this function does not work.

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT allow the conductor of the speaker 

cords to be in touch with the metallic parts of 
the System. 

1

 Hold

2

 Insert

3

 Release

1

 Hold

2

 Insert

3

 Release

 

Select for sending S-Video signals through the 
AV OUT terminal or for sending component 
video signals through the COMPONENT jacks.

 

Select for sending the composite video signals 
or RGB signals through the AV OUT terminal.

 

Progressive scanning. For a progressive TV.

 

Interlaced scanning. For a conventional TV.

VIDEO

OUT

SELECT

Y/C

RGB

PROGRESSIVE

0

PROGRE

INTER

(at the same time)

 

Connection.fm  Page 6  Tuesday, February 17, 2004  10:25 PM