Toshiba dynadock pa3686u-1set Manual De Usuario

28

Move the switch on the back of the dynadock™ to the USB 
[

] position.

Connect the provided USB cable to the Mini USB port on the 
back of the dynadock™.

Connect the other end of the USB cable to an available USB 
port on your computer.

Windows

®

 automatically detects the device and installs the 

device drivers.

Restart your computer when prompted.

Restarting may take longer than usual if the computer's operating 
system is configured to create a system restore point after a new 
device is installed. This occurs after initial installation only. When 
the computer restarts, the dynadock™ is ready to use.

Once you have set up a wireless or USB cable connection between 
your computer and the dynadock™, you can connect your 
computer peripherals to the appropriate ports on the dynadock™.

Please refer to the 

 for information on the 

dynadock's ports, and refer to the sections below for information on 
connecting specific types of devices.

Connect one end of a network cable (not provided) to the Network 
port (RJ-45) on the dynadock™ and the other end to your network. 

If the network is not automatically connected, configure the 
network properties of the Ethernet adaptor as follows:

In Windows

®

 XP, select Start, Connect to, and then Show all 

Connections.

In Windows Vista

®

, select Start, Control Panel, View     

network status and tasks, and then Manage network 
connections.