Toshiba m700-m710 Manual De Usuario

User’s Manual

6-17

Power and Power-Up Modes

If you set a Supervisor Password, some functions might be restricted when 
a user logs on with the User Password. To set a Supervisor Password, 
execute the file TOSPU.EXE. The file is located at:
C:\Program Files\Toshiba\PasswordUtility\TOSPU.exe

This utility lets you do the following:

■

Register, delete or change the Supervisor Password.

■

Create or invalidate a Supervisor Password token.

■

Specify restrictions for general users.

If you have already registered a password, there are four ways to start the 
computer:

■

Insert an SD Card token before you turn on the computer. The 
computer will start normally, without displaying a password prompt.

■

Swipe your fingerprint on the sensor if you have already registered the 
fingerprint with the Fingerprint utility and enabled Fingerprint System 
Boot Authentication. If you would not like to swipe your finger or cannot 
authenticate the fingerprint for some reasons, push the BACK SPACE 
key to skip the fingerprint authentication screen. You can try to swipe 
the fingerprint up to five times. If you failed fingerprint authentication 
five times, you must enter the password manually to start the computer.

■

Log on with the Tablet PC Pen when in Tablet mode. Refer to 

 section in this chapter.

■

Enter the password manually.

To enter a password manually, follow the steps as detailed below:

1. Turn on the power as described in Chapter 1, 

. The 

following message will appear in the screen:

S

2. Enter the Password.

3. Press ENTER.