Toshiba portege m400 Manual De Usuario

C-2

User’s Manual

AT Commands

Bn

Communication standard setting

This command determines the communication standard CCITT or Bell.

Selects CCITT V.22 mode when the modem is at 1200 bps. 

Selects Bell 212A when the modem is at 1200 bps (default).

Selects V.21 when the modem is at 300 bps.

Selects Bell 103J when the modem is at 300 bps (default).

Result Codes:

n=0,1,15,16

Otherwise

Dn

Dial

This command instructs the modem to dial a telephone number. Enter n 
(the telephone number and any modifiers) after the ATD command.

Any digit or symbol (0-9, *, #, A, B, C, D) may be dialed as touch-tone 
digits. Characters such as spaces, hyphens, and parentheses do not count. 
They are ignored by the modem, but you may want to include them to make 
the number and modifiers easier to read.

The following may be used as phone number modifiers:

Pulse dialing.

Touch-tone dialing (default).

Pause during dialing. Pause for time specified in Register S8 
before processing the next character in the dial string.

Wait for dial tone. Modem waits for a second dial tone before 
processing the dial string.

Wait for quiet answer. Wait for five seconds of silence after
dialing the number. If silence is not detected, the modem
sends a NO ANSWER result code back to the caller.

Hook flash. Causes the modem to go on-hook for 0.5 
seconds and then return to off-hook.

Return to command mode. Causes the modem to return to 
command mode after dialing a number, without 
disconnecting the call.

Dial a telephone number previously stored using the &Zn=X 
command (See &Zn=X command for more information). The 
range is 0-3.

En

Echo command

This command controls whether or not the characters entered from your 
computer keyboard are displayed on your monitor (echoed) while the 
modem is in command mode.

Disables echo to the computer.

Enables echo to the computer (default).