Toshiba portege m400 Manual De Usuario

C-8

User’s Manual

AT Commands

&Tn Self-test commands

These tests can help to isolate problems if you experience periodic data 
loss or random errors. 

Abort. Stops any test in progress.

Local analog loop. This test verifies modem operation, as 
well as the connection between the modem and computer. 
Any data entered at the local DTE is modulated, then 
demodulated, and returned to the local DTE. To work 
properly, the modem must be off-line.

Result Codes:
OK

n=0

n=1

Otherwise

&V Display Current Configuration

This command displays the current configuration of the modem. If 
nonvolatile memory is supported the stored profiles are displayed as well.

View profiles.

&W Store current configuration

Saves the current (active) configuration (profile), including S-Registers.

The current configuration comprises a list of storable parameters illustrated 
in the &V command. These settings are restored to the active configuration 
upon receiving a Zn command or at power up. Refer to the &V command.

Stores the current configuration.

&Zn=x Store telephone number

This command is used to store up to four dialing strings in the modem’s 
nonvolatile memory for later dialing. The format for the command is 
&Zn=“stored number” where n is the location 0-3 to which the number 
should be written. The dial string may contain up to 34 characters. The 
ATDS=n command dials using the string stored in location n.

Result Codes:
OK

n=0, 1, 2, 3

Otherwise

\Nn Error control mode selection

This command determines the type of error control used by the modem 
when sending or receiving data.

Buffer mode. No error control.

Direct mode.

MNP or disconnect mode. The modem attempts to connect 
using MNP2-4 error control procedures. If this fails, the 
modem disconnects. 

This is also known as MNP reliable mode.