Toshiba satellite p200 p205 Manuales De Servicio

[CONFIDENTIAL]  

  

39

The Finger printer board or system board may be the reason of a finger printer fault. Either of 

these two components may be damaged. To determine if the computer’s Finger printer is 

functioning properly, perform the following procedures. Figure 2-14 outlines the process. 

Start with Procedure 1 and continue with the other procedures as instructed. 

Procedure 1:  Diagnostic test 

Procedure 2:  Connector and replacement check 

Run the Diagnostic Program, which will automatically execute the Finger printer test.  Refer 
to Chapter 3, Tests and Diagnostics for more information on the program. 

If an error is located, go to Procedure 2.  If an error is not located, the Finger printer system is 
functioning properly. 

 

The Finger printer board or system board may be disconnected or damaged.  Disassemble the 
computer following the steps described in Chapter 4, Replacement Procedures, and perform 
the following checks. 

 

Check 1 

Make sure that the Finger printer board FFC is securely slotted into the system 
board. If the problem persists, go to Check 2. 

Check 2 

The Finger printer board may be damaged. Replace it with a new one following 
the instructions in Chapter 4. If the problem still exists, perform Check 3. 

Check 3 

The system board may be damaged.  Replace it with a new one following the 
instructions in Chapter 4.