Toshiba SD-R1102 Manual De Usuario

2

The following steps must be performed to properly install your CD-RW/DVD-

ROM.

● Set drive’s jumpers
● Connect audio cable
● Attach IDE BUS cable
● Connect power cable
● Mount CD-RW/DVD-ROM
● Install CyberLink PowerDVD

™

 software (used for viewing DVD movies)

● Install VOB InstantCD/DVD software (used for recording CDs)

The mode select jumpers are six (6) straight angle pins located on the rear of the
CD-RW/DVD-ROM. By placing a jumper on the pins, you can select the following
functions:

CS: – Drive is configured using host interface signal CSEL
SL: – Configures drive as Slave
MA: – Configures drive as Master (default mode)

In most installations, jumper should remain in MA (Master) position (factory
default). It is recommended that you install your CD-RW/DVD-ROM only on the
secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive
would then be the Master, and you should set your CD-RW/DVD-ROM to the
Slave position (SL).

Now that you have set your drive’s  jumpers, you are ready to install your
CD-RW/DVD-ROM inside your computer.

☞

☞

☞

☞

☞

C

S

S

L

M

A