kymco mo movie125150 Manuales De Servicio

ASSEMBLY
Apply grease to the dust seal in the front

cover.

Install the brushes onto the brush holders.

Apply a thin coat of grease to the two ends

of the armature shaft.

Insert the commutator into the front cover.

Install a new O-ring to the front cover.

Install the starter motor case, aligning the tab

on the motor case with the groove on the

front cover.

Tighten the starter motor case screws.

INSPECTION
Remove the frame body cover. (!2-2)

Turn the ignition switch ON and the starter

relay is normal if you hear a click when the

starter button is depressed.

If there is no click sound:
• Inspect the starter relay voltage
• Inspect the starter relay ground circuit
• Inspect the starter relay operation

STARTER RELAY VOLTAGE INSPECTION
Place the motorcycle on its main stand.

Measure the voltage between the starter relay

connector green/yellow wire (-) and engine

ground.

Turn the ignition switch ON and the battery

voltage should be normal when the brake lever

is fully applied.

If the battery has no voltage, inspect the stop

switch continuity and cable.

AC 110V

Front  Cover

Groove

Commutator

Motor  Case

Grease

O-ring

Tab

• Be careful not to damage the brush and

armature shaft mating surfaces.

• When installing the commutator, the

armature shaft should not damage the

dust seal lip.

＊

When assembling the front cover and

motor case, slightly press down the

armature shaft to assemble them.

＊

Green/Yellow Wire

Starter Relay