kymco mo x500 Manuales De Servicio
12
. A.C. GENERATOR/STARTER CLUTCH
12-3
XCITING 500
ALTERNATOR STATOR
REMOVAL
Remove the right center body cover (page 2-
5).
Remove the exhaust muffler (page 2-15).
Remove water pump (page 6-10).
5).
Remove the exhaust muffler (page 2-15).
Remove water pump (page 6-10).
Remove the fifteen bolts and right crankcase
cover, dowel pins and gasket.
cover, dowel pins and gasket.
Remove the two pulse coil mount bolts.
Remove the three stator mount bolts,
grommet and the stator from the right
crankcase cover.
Remove the three stator mount bolts,
grommet and the stator from the right
crankcase cover.
INSTALLATION
Install the stator and tighten the stator mount
bolts to the specified torque.
Install the stator and tighten the stator mount
bolts to the specified torque.
Torque: 12 N•m (1.2 kgf•m, 9 lbf•ft)
Apply sealant to the grommet seating surface
and install it to the cover groove properly.
and install it to the cover groove properly.
Install the pulse coil and tighten mount bolts
to the specified torque.
to the specified torque.
Torque: 12 N•m (1.2 kgf•m, 9 lbf•ft)
Clean the mating surfaces of the right
crankcase and cover.
crankcase and cover.
Install the dowel pins and gasket.
Install the right crankcase cover and tighten
the bolts in a crisscross pattern in 2 or 3 steps.
Install the right crankcase cover and tighten
the bolts in a crisscross pattern in 2 or 3 steps.
Right Crankcase Cover
Dowel Pins Gasket
Bolts Pulse Coil
Stator Bolts Grommet