kymco mo kxr 250 Manuales De Servicio

ASSEMBLY
Install the slow jet.

Install the needle jet, needle jet holder and

main jet.

Install the throttle stop screw and air screw

Install the spring, diaphragm and O-rings.

Install the float valve, float and float pin.

FLOAT LEVEL INSPECTION
Turn the carburetor upside down so that the

float will go down to make the float valve

contact the float valve seat.

Then slowly tilt the carburetor and measure

the float level with the float level gauge while

the float pin just contacts with float valve.

Float Level: 14.8mm

When adjusting, carefully bend the float pin.
Check the float for proper operation.

Install the jet holder, aligning the jet holder

groove with the carburetor tab and then

install the float chamber.

Reverse the “ CARBURETOR REMOVAL”

procedures.

Refer to the “AIR CLEANER” section in the

chapter 3 for air cleaner replacement and

cleaning.

• When installing the air screw, return it

to the original position as noted during

removal

• After the carburetor is installed, be sure

to perform the Exhaust Emission Test.

Jet Holder