kymco mo mxu250 Manuales De Servicio

INSPECTION
Disconnect the neutral/reverse switch wire

connector. (See page 6-4)

Check for continuity between the switch

side connector terminal and engine ground.

NEUTRAL SWITCH
There should be continuity with the

transmission in neutral and no continuity

with it in any gear except neutral.

REVERSE SWITCH
There should be continuity with the

transmission in reverse and no continuity

with it in any gear except reverse.

REPLACEMENT
Remove drive and driven pulley. (Refer to

chapter 9)

Remove the two bolts and set plates.
Remove neutral/reverse switch.

Install a new switch with a new O-ring.

Set Plates

Bolts

Make sure that the lever on the

neutral/reverse switch correctly engages

with the locating slot on the shift shaft.

＊

Neutral/Reverse Switch

O-ring

Lever