Yamaha aw1600 Manual De Usuario

9

Mixdo

wn and bounce oper

ations

AW1600  Owner’s Manual

During mixdown or bouncing, you can watch meters that 
indicate the input levels in a single screen. To do so, 
repeatedly press the Selected Channel section [VIEW] key 
or hold down the [VIEW] key and use the CURSOR [

]/

[

] keys to access the METER page of the VIEW screen.

In the METER page, the display will change depending on 
the channel that is currently selected (shown in the upper 
left of the screen). Press an [INPUT SEL] key to view the 
meters for the input channels/pad channels, or press a 
[TRACK SEL] key to view the meters for the track chan-
nels.

● If a track channel is selected

● If an input channel/pad channel is selected

1 PEAK button

This button switches the level meter peak hold function 
on/off. When this button is on, a 

 indicator will show 

the peaks of the level meters, and this indicator will be 
held. To reset the indicator, temporarily turn off the PEAK 
button. This setting is shared with the BUS page of the 
VIEW screen.

B

These buttons select whether the level meters in the 
METER page will indicate the pre-fader levels (PRE) or 
the post-fader levels (POST). This setting is independent 
from the BUS page of the VIEW screen.

C

These indicate the input level of each channel.

Sometimes you will want to see all mix parameters for a 
certain channel in a single screen. To do this, repeatedly 
press the Selected Channel section [VIEW] key or hold 
down the [VIEW] key and use the CURSOR [

]/[

] 

keys to access the CH VIEW page of the VIEW screen. 
(Some items can also be edited from this page.)
The display in the CH VIEW page will change depending 
on the currently selected channel (shown in the upper left 
of the screen). Use the [INPUT SEL] keys, pads 1–4, 
[TRACK SEL] keys, and [STEREO SEL] key to select the 
channel that you want to view.

● If an input channel, pad channel, or track 

● If the stereo output channel is selected

1 Pairing

Indicates the pairing status of adjacent odd-numbered/
even-numbered channels. Paired channels are indicated by 
a heart-shaped symbol, and unpaired channels are indi-
cated by a broken heart.
Move the cursor here and press the [ENTER] key to 
switch pairing on/off.

B

Move the cursor to this knob and turn the [DATA/JOG] 
dial to adjust the attenuation of the signal over a range of 0 
to –96 dB before it enters the EQ. This is the same func-
tion as the ATT. knob in the EDIT page of the EQ screen.

C

Move the cursor here and press the [ENTER] key to 
switch the phase of the signal between N (Normal) and R 
(Reverse).

Using meters to check 
the level of each channel

1

3

2

1

3

2

Viewing all parameters for a 
certain channel

2 3 4 5 6

M K L

7

1

89

J

2

4 5 6

N

7

L