Yamaha D5000 Manual De Usuario
8 - Program Select Mode
D5000
Press the
[ > ] "
RECALL
" CURSOR key.
If you have not made any changes to the previous settings, it will be replaced with the new
program.
program.
If you made a mistake selecting the new program or you decide you do not want to replace the
current program, you can cancel the RECALL operation by pressing any key except the
current program, you can cancel the RECALL operation by pressing any key except the
[ > ]
"
RECALL
" CURSOR key.
Storing a program
Storing a program overwrites the data that was previously stored under that program number. If
you decide that you do not want to replace the program or that you made a mistake selecting the
program number, you can cancel the STORE operation by pressing any key other than the
you decide that you do not want to replace the program or that you made a mistake selecting the
program number, you can cancel the STORE operation by pressing any key other than the
[ < ]
"
STORE
" CURSOR key.
If you have made changes to the previous settings without storing them,
the unit will additionally display the message "
the unit will additionally display the message "
Are you sure?
" on the
LCD. Press the
[ > ] "
RECALL
" CURSOR key again to complete your
selection. The previous program will be replaced with the new program.
Press the
[ PROGRAM ] key to enter Program Select Mode. The LED on the
key will light and the LCD will display the title of the current program.
Press the
[ < ] "
STORE
" CURSOR key. The message "
[STORE]
" will be
displayed on the LCD along with a message showing the "
From:
" and
"
To:
" program numbers.
NOTE
If the SOFTWARE PROTECT parameter of Utility Mode is not set to OFF, the LCD will temporarily
display the message "
display the message "
Protected !
" when you attempt to store a program.
Rotate the DATA ENTRY encoder or press the
[ ^ ] and [ % ] CURSOR keys
to select the program number that you want for use to storing your
settings.
settings.
Press the
[ < ] "
STORE
" CURSOR key again to confirm that this is what you
want to do. The message "
Complete !
" will briefly appear on the LCD.