Yamaha htr-5890 Manual De Usuario
25
CONNECTIONS
PRE
P
ARA
T
ION
If you are using 6 ohm speakers, set the impedance to
6 ohms as follows before turning on the power.
6 ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while holding down
SPEAKERS A, press STANDBY/ON.
SPEAKERS A, press STANDBY/ON.
“SP IMP.SET” appears in the front panel display for a
few seconds, then “Minimum 8ohms” appears.
few seconds, then “Minimum 8ohms” appears.
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 63) to set the speaker
impedance.
impedance.
When all connections are complete, turn on the power of
this unit.
this unit.
1
Press STANDBY/ON (SYSTEM POWER on the
remote control) to turn on the power of this
unit.
remote control) to turn on the power of this
unit.
2
Turn on the video monitor connected to this
unit.
unit.
Press STANDBY/ON again (STANDBY on the remote control)
to enter the standby mode.
to enter the standby mode.
Speaker impedance setting
CAUTION
STANDBY
/ON
SP IMP.SET
Minimum 8ohms
SPEAKERS
A
Turning on the power
Note
PRESET/TUNING
EDIT
FM/AM
A/B/C/D/E
PRESET/TUNING
INPUT MODE
TONE CONTROL
MULTI CH
INPUT
STRAIGHT
EFFECT
MEMORY
MAN'L/AUTO FM
TUNING MODE
AUTO/MAN'L MONO
VOLUME
PROGRAM
INPUT
STANDBY
/ON
OPTIMIZER
MIC
PHONES
SILENT CINEMA
SPEAKERS
A
B
OPTICAL
R
AUDIO
L
VIDEO
S VIDEO
VIDEO AUX
PURE DIRECT
A/B/C/D/E
1
SELECT
DTV
DVR/VCR2
VCR 1
DVD
V-AUX
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER
CD
MULTI CH IN
+
POWER
POWER
POWER
SYSTEM
STANDBY
AV
TV
SLEEP
INPUT MODE
A
B
+
+
AMP
1
STANDBY
/ON
POWER
SYSTEM
or
Front panel
Remote control
01EN00_HTR5890U.book Page 25 Thursday, December 23, 2004 12:39 PM