Yamaha R-S500BL Manual De Usuario

To use this unit’s remote control to control other 
components (TV, DVD player, VCR, etc.), determine the 
remote control code that corresponds to the component 
and assign that code to the desired input selector button on 
the remote control. Remote control codes are listed in the 
“LIST OF REMOTE CONTROL CODES” at the end of 
this manual.

■ Default remote control configuration

The remote control is configured at the factory as shown 
below.

If you cannot operate a Yamaha component when the remote 
control is configured using the remote control code listed above, 
refer to the “LIST OF REMOTE CONTROL CODES” at the end 
of manual and try assigning a different Yamaha remote control 
code.

■ Assigning remote control codes

Refer to the “LIST OF REMOTE CONTROL 
CODES” at the end of this manual and 
determine the remote control code that 
corresponds to each of your components.
Components are listed by category (TV, VCR, DVD 
player, etc.) and manufacturer.

Press an input selector button on the remote 
control to select the input source you want to 
configure.
You can also press TV A to configure the TV control 
buttons (see page 47).

Use the numeric buttons on the remote 
control to enter the four-digit remote control 
code corresponding to the component you 
want to assign.
When the component has been assigned, “OK” is 
displayed on the front panel display. If an error 
occurs, “NG” is displayed.

• If the manufacturer of your component has more than one 

remote control code, assign each code one at a time until you 
find the code that successfully controls your component.

• You can only assign one remote control code to each input 

selector button.

■ Resetting the remote control

Use this procedure to reset the remote control codes 
assigned to each input selector to the factory default (see 
“Default remote control configuration” above).

This procedure will be cancelled if you do not press any buttons 
for 1 minute. If the procedure is cancelled, repeat from step 1 if 
necessary.

Use the numeric buttons on the remote 
control to enter “9981”.
The remote control code assigned to each input 
selector button will be reset to its factory default 
code.

CD

CD player

Yamaha

5082

TAPE

TAPE deck

Yamaha

5087

PHONO

—

—

—

LINE 1

CD recorder

Yamaha

5083

LINE 2

DVD player

Yamaha

2082

LINE 3

Blu-ray disc 

player

Yamaha

2064

TV A 

—

—

—

TV A