Yamaha RX-V1900BL Manual De Usuario

Input/output assignment
I/O ASSIGNMENT
Use this feature to assign the input/output jacks according 
to the component to be used if the initial settings of this 
unit do not correspond to your needs. Change the 
parameter to reassign the respective jacks and effectively 
connect more components.
Once the input/output jacks are reassigned, you can select 
the corresponding component by using the CINPUT 
selector (or the input selector buttons (3)).

y

• “NONE” appears in the OSD when no input source is assigned 

to the jack.

• You cannot select a specific item more than once for the same 

type of jack.

• An asterisk (*) appears to the right of the jack names that have 

been changed from their previous settings.

• The input source currently assigned to the selected jack is 

shown in the parentheses next to “Current”.

INPUT RENAME

Use this feature to change the name of the input source (up 
to 9 characters) that appears in the OSD and in the front 
panel display.
• To locate the position to edit , press 8l / h.
• To select a character, press 8k / n.
• To confirm the setting, press 8ENTER.
• To return to the previous screen without change, press 

9RETURN.

y

Press 8n to change the character in the following order, or 
press 8k to go in the reverse order: A to Z, 0 to 9, a to z, 
symbols (#, *, –, +, etc.), space.

VOL. TRIM

Use this feature to adjust the level of the signal input at 
each jack. This feature is useful if you want to balance the 
level of each input source to avoid sudden changes in 
volume when switching between input sources.
Control range: –6.0 dB to +6.0 dB
Control step: 0.5 dB
Initial setting: 0.0 dB

y

This parameter also affects the signals output at the audio 
ZONE OUT jacks.

DECODER MODE

Use this feature to switch the decoder activation mode.

“DECODER MODE” is available only when the digital audio 
input jacks (HDMI, OPTICAL and/or COAXIAL) are assigned 
to the selected input source.

BGV

Use this feature to select the video source played in the 
background of the selected audio input source.

STANDBY CHARGE

Use this feature to select whether this unit charges the 
battery of the stationed iPod or not when this unit is in the 
standby mode.

START PAIRING

Use this feature to start pairing the connected Yamaha 
Bluetooth wireless audio receiver (such as YBA-10, sold 
separately) with your Bluetooth component. For details 
about the pairing, refer to “Pairing the Bluetooth™ 
receiver and your Bluetooth component” (page 65).

Press 8

ENTER to start pairing. 

The connected Bluetooth receiver starts searching 
Bluetooth components. “Searching...” appears in the 
OSD.

Check that the Bluetooth component detects 
the Bluetooth receiver.
For details, refer to the instruction manual of the 
Bluetooth component.

Automatically detects digital audio signal input 
types and selects the appropriate decoder.

DTS

Activates the DTS decoder and plays back only 
DTS digital audio signals when digital audio 
signals are input.

BD/HD DVD, 
DVD, CBL/
SAT, DVR, 
VCR, V-AUX, 
DOCK

Selects the corresponding input source as the 
background video source.

Does not play the video source in the 
background.

Charges the battery of the stationed iPod when 
this unit is turned on and in the standby mode.

OFF

Charges the battery of the stationed iPod only 
when this unit is turned on.

To ensure security, a time limit of 8 minutes is set for 
the pairing operation. You are recommended to read 
and fully understand all the instructions before starting.