Electro-Voice p1 rigging Manual De Usuario
12000 Portland Avenue South, Burnsville, MN 55337
Phone:952/884-4051, Fax:952/884-0043
Phone:952/884-4051, Fax:952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 12/2003
Part Number 38110-333 Rev B
Part Number 38110-333 Rev B
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
Figure 3:
Attaching the PSA-V to the Plasma P1
Figure 4:
Attaching the Truss Clamp to the PSA-V
Each P1 has three L-tracks embedded, one on the top, one on the bottom, and one on the flat
side. Each L-track has a threaded hole in the center, this threaded hole is used to mount the
PSA-V as shown in Figure 3. Align the PSA-V’s threaded shaft with the L-track’s threaded hole
and carefully screw it in. The knob can now be hand tightened to position the P1 at the angle
desired.
side. Each L-track has a threaded hole in the center, this threaded hole is used to mount the
PSA-V as shown in Figure 3. Align the PSA-V’s threaded shaft with the L-track’s threaded hole
and carefully screw it in. The knob can now be hand tightened to position the P1 at the angle
desired.
If used with the optional truss clamp carefully insert the spigot into the truss clamp as shown in
Figure 4 and insert the safety pin. Make sure to push the safety pin all the way in and bend
the tip over to secure it in place. The PSA-V with Truss clamp and Plasma P1 can now be
carefully attached to a truss. The user should make certain the truss is capable of safely
supporting the Plasma P1. The Plasma P1 with arm can now be rotated to the desired position,
when aimed, tighten the locking knob on the truss clamp to secure the spigot and arm in position.
Good rigging practice includes using a second safety point. Please connect a second L-track on
the Plasma P1 using a rated stud fitting and hardware to a secure suspension point.
Figure 4 and insert the safety pin. Make sure to push the safety pin all the way in and bend
the tip over to secure it in place. The PSA-V with Truss clamp and Plasma P1 can now be
carefully attached to a truss. The user should make certain the truss is capable of safely
supporting the Plasma P1. The Plasma P1 with arm can now be rotated to the desired position,
when aimed, tighten the locking knob on the truss clamp to secure the spigot and arm in position.
Good rigging practice includes using a second safety point. Please connect a second L-track on
the Plasma P1 using a rated stud fitting and hardware to a secure suspension point.
Insert Safety Pin
through Hole
Safety Pin
Insert Spigot into
Truss Clamp
Spigot
Truss
Clamp
Locking Knob
Insert Threaded Shaft of
PSA-V into Threaded Hole
of L-Track
Front View
Side View
Threaded Hole in
L-Track
PSA-V Strong-Arm
Locking Knob