Epson MovieMate 30s Manual De Usuario

Using MovieMate With Other Equipment

You can connect MovieMate to an audio receiver, 5.1 Stereo Surround Sound System, or 
digital audio recorder. To output sound from MovieMate, the external equipment needs to 
have an optical audio input port.

Note: For additional convenience, Epson has developed an optional Wireless 5.1 Surround Sound 
System adapter for the MovieMate 30s Series. To find out more about this accessory, go to 
www.epson.com/homeentertainment.

You will also need an optical digital cable, which may be provided with your external 
equipment, or may be purchased from an electronics store.

1. Remove the protective cap from the 

Optical Audio-Out

 port and keep it in a safe place.

2. Make sure the equipment is turned off, then connect the cable as shown:

3. Turn on your audio equipment and play your movie, music, or other presentation with 

sound from MovieMate.

4. You can adjust the volume input level by pressing and holding the 

 button for 

approximately 2 seconds. 

LEVEL 1

 appears on MovieMate’s display window. Press and 

hold the button again to select 

LEVEL 2

 and increase the volume. 

You may also need to change the 

Digital Audio Output

 or 

Downmix 

settings in the 

Audio Setup menu. Make sure you use the 

Stream/PCM

 setting for surround sound 

systems. You can also use any of MovieMate’s other audio controls, as described on 
pages 42 through 43.

Note: After you disconnect your external audio equipment, make sure you replace the cap on the 
Optical Audio Out port and close MovieMate’s port compartment cover.

Optical digital cable

Audio receiver

Digital audio recorder

Wireless 5.1 Surround 
Sound System adapter 
(audio transmitter 
portion)