Echo SHC-225 Manual De Usuario

 

Level 1.

Hedge Clipper drive shaft should be greased every 25 hours of 

operation.

Tools required:     Torx T27 L-Wrench, screwdriver, clean rag, small 

brush

Parts required:    POWER BLENDX

TM 

14 oz. cartridge or Lithium 

Based Grease

Hedge Clipper blades are very sharp.  Touching them may lead to 

severe personal injury.  Avoid touching blades whenever possible, 

and always wear gloves to protect hands. 

1.  Remove gear housing locating screw (A) and clamping screw (B).  

Remove the gear housing assembly from the drive shaft housing.

2.  Pull the drive shaft (C) from the housing, wipe clean and re-coat 

with a thin coating  [1/2 oz. (15 ml)] of grease.

3.  Slide the drive shaft back in the drive housing being careful not to 

get dirt on the flex shaft.

4.  Install the gear housing assembly.

Flat edge of washers (D) must be against drive shaft.

Tools required:   Flat  file, screwdriver

Parts required:   None

Hedge Clipper blades are very sharp.  Touching them may lead to 

severe personal injury.  Avoid touching blades whenever possible, 

and always wear gloves to protect hands.