Echo SRM-225 Manual De Usuario

Level 1.

Tools Required:   13mm Open End Wrench, T27 Torx L-Wrench,  

 

 

 

 

Clean Rag, Grease Gun

Parts Required:   POWER BLENDX

TM

 8 oz. (P/N 91014) or    

 

 

 

 

Lithium Base Grease.

1.  Clean all loose debris from gear box.

2.  Remove plug (A) and check level of grease.

3.  Add grease if necessary. DO NOT over-fill.

1.  Loosen two (2) screws (B) and remove center locating screw (C).   

Pull gear box and shield from drive shaft housing.

2.  Pull flexible cable from the drive shaft housing, wipe clean and  

re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3.  Slide the flexible cable back in the drive housing.  DO NOT get  

dirt on the flex cable.

4.  Install the gear housing and shield assembly.

Flat edge of washers (D) must be against drive shaft.