Echo shred'n'vac es-210 Manual De Usuario

The starting procedure is the same as Cold Start except DO NOT close
the choke.

1.

Stop Switch
Move stop switch button (A) away from the STOP position.

2.

Throttle Position Lever
Move throttle position lever (B) forward to idle position.

3.

Primer Bulb
Pump primer bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4.

Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope (E) until
engine fires.

IMPORTANT
Recoil starter:  Use short pulls - only 45 ~ 60 cm (18 ~ 24 in.) of
rope for starting.  Do not allow the rope to snap back in.  Always
hold the unit firmly.

NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.

1.

Release throttle trigger (F). Move throttle position lever (B)
forward to idle position and allow engine to return to idle before
shutting engine off.

2.

Stop Switch
Move stop switch (A) to “STOP” position.

If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.