Aleratec 330107 Manual De Usuario

www.aleratec.com

30

This function allows you to set the time to exit Asynchronous Copying 

when you pull all the USB flash drives out of the duplicator. The default 

setting is 30 seconds. If after 30 seconds no new drives are plugged into 

the USB Duplicator the LCD will ask to exit Asynchronous or to stay in 

Asynchronous mode. Press OK to exit Asynchronous Copying or press 

ESC to keep this status. 

To change the default setting for Asyn Hold Time use the following 

procedure:

1.  Use the UP or DOWN arrow to scroll through the menu until Setup is 

displayed on the LCD screen. Press the OK button to select. 

2.  Use the UP or Down arrow to scroll through the Setup options until 

Asyn Hold Time is displayed on the LCD screen. Press OK.

3.  Default setting is 30 seconds; press the arrow keys to change. Press 

ESC to exit.

To make sure the FAT table of each flash drive was copied correctly all 

source and target flash drives should be the same capacity. Each flash drive 

potentially has some capacity difference due to the manufacturing process. 

To ensure both the source and target flash drives are at the same capacity 

you can set the capacity tolerance. This function is used to set the tolerance 

% of flash capacity difference between source and targets.











