Snapper 11305 Manual De Usuario

 

 

 
4.1.4.  WHEEL DRIVE BELT REPLACEMENT 
Inspect belt frequently for signs of excessive wear. 
Visually check engine drive belt for cracking, 
fraying, severed or exposed belt strands. 
1.  Remove belt cover. See Figure 4.2. 
2.  Remove discharge chute. 
3.  Unhook both idler springs. 
4.  Loosen auger/impeller belt guide. See Figure 4.6. 
5.   

IMPORTANT: Auger  drive belt will have to be removed 
from around engine drive pulley and engine shaft to 
install wheel drive belt. 
 

6.  Remove wheel drive belt from around engine 
pulley. See Figure 4.6. 
 
 

 

 

 

 
 
 
 
 
 
 
 

7.  Tilt machine forward to gain access to drive 
system area. Secure machine in the tilted position 
to prevent tipping over. Remove drive system cover 
plate. See Figure 4.7. 
 

 

 

 
7.  Remove wheel drive belt from drive disc pulley. 
Route wheel belt through drive system in between 
rubber drive tire and drive disc. 
8.  Route new wheel drive belt through drive 
system.  NOTE: New belt has to be routed in 
between rubber drive tire and drive disc to position 
it around auger pulley.  
9.  Route wheel drive belt onto engine wheel drive 
pulley. Make sure belt is also positioned in the drive 
disc pulley groove. 
10.  Reinstall auger drive belt around engine auger 
drive pulley. Make sure belt is also positioned in the 
drive disc pulley groove. 
11.  Position belt guide against auger drive belt and 
tighten securely.  
12.  Reinstall both idler springs. 
13.  Reinstall discharge chute, belt cover and drive 
system cover . Tighten screws securely.