Autostart as-2510 tw Manual De Usuario
LCD Transmitter Operation and Confirmations
(Second Car Control)
Basic Operations
FUNCTION
BUTTON PRESS
ICON
BUZZER
DESCRIPTION
LOCK
+
1 Beep
UNLOCK
+
2 Beep
START
+
+
MELODY
STOP
+
None
MELODY
TRUNK
+
+
TRUNK on vehicle
will pop up
BEEP
Start/Stop While in Safe Start Mode
FUNCTION
BUTTON PRESS
ICON
BUZZER
DESCRIPTION
START ON
SAFE START
MODE
+
X 2
+
MELODY
Press
+
simultaneously twice within
3 seconds. Press for 1
sec- a BEEP will be heard-
then press 1sec and a
melody will be heard
again.
STOP ON SAFE
START MODE
+
None
MELODY
Timing and Alarm Adjustment
To apply changes to the hours, minutes melody, etc. you must press and hold the Function button
for three (3) seconds after which the hour position will start to flash. To navigate through the
options, simply press the Function button until you reach the desired position.
Transmitter Finder
If the remote is misplaced, the user can locate it by calling it. In order to do so, press and hold the
Valet switch for three (3) seconds or until the Parking Lights flash five (5) times. The Transmitter
will start beeping. It will beep for a maximum of 60 seconds and then it will stop. If the user
retrieves the Transmitter before the 60 seconds are up, he can press the
To apply changes to the hours, minutes melody, etc. you must press and hold the Function button
for three (3) seconds after which the hour position will start to flash. To navigate through the
options, simply press the Function button until you reach the desired position.
Transmitter Finder
If the remote is misplaced, the user can locate it by calling it. In order to do so, press and hold the
Valet switch for three (3) seconds or until the Parking Lights flash five (5) times. The Transmitter
will start beeping. It will beep for a maximum of 60 seconds and then it will stop. If the user
retrieves the Transmitter before the 60 seconds are up, he can press the
LOCK
or
UNLOCK
button to
stop the beeping.
Remote-starting Your Vehicle
Press the
Press the
START/STOP
button for approx. 1 second, the icon “run” will flash for confirmation. The
icon will stop flashing when the key is inserted and turned to the “ON” position or when the entire
pre-programmed engine run time has elapsed.
If the vehicle doesn’t start the first time, the system will shut off, wait a few seconds and try to start
the engine again. It will make three start attempts before giving up.
pre-programmed engine run time has elapsed.
If the vehicle doesn’t start the first time, the system will shut off, wait a few seconds and try to start
the engine again. It will make three start attempts before giving up.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
AS-2510 TW User Guide
P. 8
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.