Agri-Fab 45-03621 Manual De Usuario

8

•  Place Towbar Tube into Rear Quadrant, align holes and

insert 3/8 x 2-3/4 Hex Bolt through quadrant and rear
hole of Tube.

•  Secure tightly with 3/8 Hex Lock Nut and then loosen

1/4 turn to allow Tube to pivot freely inside Rear
Quadrant.

•  Insert 3/8 X 2-3/4 Bolt and 3/8 Flat Washer into slot in

Rear Quadrant and into hole in Towbar Tube.

•  Secure Tightly with 3/8 Flat Washer and 3/8 Hex Lock

Nut, then loosen 1/4 turn to allow Tube to pivot freely
inside Rear Quadrant.

NOTE: Towbar Tube must pivot freely inside Rear Quadrant 

when Latch is pulled from notch.

•  Place Clutch Cable forward along Towbar Tube.
•  Spread ends of two Cable Clips and place around

Clutch Cable.

•  Place Clutch Cable on top of Towbar Tube and align

Cable Clips with bolt holes in Towbar Tube.

•  Secure with two #10 Screws.

Your Trail Mower requires a 12 volt battery to operate. The
battery is NOT included with the unit. It must be purchased 
separately.
•  Remove four screws and the Battery Cover from the

Mower and set them aside.

•  Install two Plastic Nuts into the square holes in the

Mower Deck under the Battery Cover.

•  Place the Battery on the Mower Deck between the two

Plastic Nuts.

•  Place the Battery Hold Down on top of the Battery.
•  Secure the Battery to the Mower Deck with two
 1/4 x 7-1/2 hex bolts.
•  Open the terminal access doors on the Battery Hold

Down.

•  Connect the Red Wire to the positive (+) battery terminal

using a 1/4 x 3/4 hex bolt and 1/4 SEMS nut. Tighten
securely.

•  Connect the Black Wire to the negative (-) battery

terminal using a 1/4 x 3/4 hex bolt and 1/4 SEMS nut.
Tighten securely.

•  Close the terminal access doors.
•  Replace Battery Cover and secure it with the four

screws.

•  Remove outer 5/16 Nut from end of Clutch Cable

Housing. (See Fig. 1)

•  Turn inner 5/16 Nut to bottom of thread.
•  Insert Cable and outer 5/16 Nut through slotted hole

in Cable Guide of Hitch Assembly. The outer 5/16 Nut 
musts be cocked sideways to insert through slotted hole 
of Cable Guide.

•  Reinstall outer 5/16 Nut to the cable housing to secure

Cable Harness to Cable Guide.

•  Install Mounting Anchor of Clutch Cable to Clutch Lever

using Clevis Pin and Hair Cotter Pin.