Coleman 2000000583 Manual De Usuario

NOTE: Make sure tab on each
pole locks into slot on bottom
of Hub.
(Fig. 5)

TM   

STITCH LINE

1. Unfold tent and spread out on a clean, level surface with the 

door facing the desired direction. Unzip doors. (Fig. 1)

4. Insert end of first Short Ridge Pole (with 

dot) into flange with a dot on Hub (Fig. 3).
Repeat for remaining Short Ridge Pole on 
opposite flange of Hub with a dot.  

NOTE: When installed properly, the loop on 

the bottom of the Hub will be parallel 
two Short Ridge Poles.

5. Insert four remaining Long Ridge Poles into Hub. (Fig. 4)

7. Insert curved end of four Short 

Leg Poles into the four Long 
Ridge Poles on top of tent.
(Fig. 7)

NOTE: Make sure tab on each Long 

Ridge Pole locks into slot on 
each Short Leg Pole.

9. Raise tent by assembling shock-corded sections of each 

Long and Short Leg Pole and inserting into curved ends of 
Leg Poles. (Fig. 9)

10. Insert pin on loop at 

each corner and the
front and back of tent 
into all six Leg Poles. 
(Fig. 10)

11. Locate both plastic hooks at each corner, 

and front and back of tent, then snap 
onto Leg Poles to attach. (Fig. 11)

12. Drive stakes through rings, located on 

four corners and front and back of tent,
at an angle for better anchoring.
(Fig. 12)

Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard

or sharp objects, to install your tent.

•  Do not set up your tent under trees.
•  For best results in windy conditions, position end of tent into

the wind.

•  Enlist the help of at least one other person to assist you when 

it is time to assemble the tent.

2. Insert the two Short Ridge Poles (with sticker dots) into the 

sleeves (perpendicular to door) on top of tent. (Fig. 2)

3. Assemble four, shock-

corded, Long Ridge 
Poles and insert into
the four diagonal corner 
sleeves. (Fig. 2)

8. Insert curved end of two Long Leg Poles (with dots) into the 

Short Ridge Poles at front & back of tent. (Fig. 8)

NOTE: Make sure tab on each Short Ridge Pole  locks into slot 

on each Long Leg Pole.

6. Snap hook at top of tent onto metal loop

on bottom of Hub. (Fig. 6)

1. Drape Rainfly over 

tent. Make sure 
seams on Rainfly 
are facing down
with web pockets 
and long straps
centered over doors 
& back of tent.
(Fig. 13)

2. Locate and wrap hook and

loop fasteners, on underside of 
Rainfly, and wrap around the
Leg Poles to secure. (Fig. 14) 

(continued on other side)

Hub (1)

5010000120

Short Ridge Pole (2)

5010000121

Long Leg Pole (2)

5010000122

Short Leg Pole (4)

5010000123

Long Ridge Pole (4)

5010000124

Awning Pole (2)

5010000125

Rainfly (1)

5010000126

Hub (1)

Short Ridge Poles (2)

Long Ridge

Poles (4)

Long Leg Poles (2)

Awning Poles (2)

Short Leg

Poles (4)