Epson M X - 8 0 Manual De Usuario

(8)

Character sizes and maximum column lengths can be specified as follows;

If you turn any of the above character sizes to the enlarged character print

mode, then the maximum column length will be reduced to a half of them.

The DIP switch No. 2 consists of the following 4 pins. A summary of the functions

of the respective DIP switch pins and their preset conditions at the time of ship-

ment are shown in Table 4.

(1) SW2-1 & 2-2: Combined use of these two pins and SW1-7 permit selection of

t h e   i n t e r n a t i o n a l   c h a r a c t e r   s e t   f o r   U . S . A . ,   F r a n c e ,   G e r m a n y ,   E n g l a n d ,

Denmark, Sweden, Italy, and Spain as shown in Table 5 upon power applica-

tion.

(2) SW2-3: This pin is used to fix AUTO FEED XT signal internally. (Refer to the

explanation of control code “CR” in paragraph 3.1 (1) “WHAT IS THE MX-80

TYPE II?“.) This signal line is wired ORed with the pin No. 14 of the interface

connector. Therefore, to control the pin No. 14 externally through TTL, etc.,

leave this DIP switch pin to the OFF position.

(3)

SW2-4: This pin is used to set the automatic skip-over perforation function.

(a) When this pin is set to the OFF position, the automatic skip-over perfora-

tion function becomes valid. By this function, the paper automatically

advances to the first line of the next page when the remaining page length

is 1 inch.

(b) When this pin is set to the ON position, the l-inch automatic skip-over

perforation function becomes invalid. However, you can activate this func-

tion programmably (described in detail later).