Thule speedway 961xt Manual De Usuario

101

Place top clips in the gap at the front edge of the top of the trunk, hatch or door.

102

Place lower clips in the bottom edge of trunk or hatch.

103

Set lower clips/hooks into vehicle's left and right tow loops under the rear of the vehicle.

104

Set lower clips/hooks into tow loop on the right and frame hole on the left.

105

Set lower clips into bottom edge of internal metal bumper.

106

Set lower clips/hooks into frame holes.

107

Set lower clips into bottom edge of rear doors.

108

Set lower clips into frame holes in back of bumper.

109

Set lower clips onto bottom edge of bumper.

110

Set lower clip/hook onto edge of structural bumper located behind plastic bumper.

111

Frame holes are located up high on the backside of bumper.

112

Set lower clip/hooks into frame holes in chassis behind bumper.

114

Chafe guards required.

115

To minimize contact between carrier tow hooks and the bumper, slide the strap through only one end of the chafe guard leavin

g the other end free to rest between the tow hook and the bumper.

116

Caution: Bumper cover may deform with the use of this carrier. Remove carrier when not in use.

117

The upper arm of the carrier, between the rubber pads, may come in contact with the center ridge in the trunk lid when carri

er is fully mounted.

118

Caution: Lower arm of the carrier will mount against the license plate and the lights to the left and right of it.

121

Caution: Rear wiper can not be used when carrier is mounted.

122

Offset carrier to the right.

124

Caution: Rear wiper must be positioned through the upper arm of carrier.

125

Important: Always check to make sure there is no contact between the lower straps and the muffler and/or exhaust pipe.

126

Caution: The trunk lid may deform slightly with the use of this carrier. Remove carrier when not in use.

127

Route top strap under the spoiler on top of the hatch.

128

Lower arm of carrier should be positioned on upper tier of bumper.

129

Rubber weather stripping at the top of door/hatch will deform over time with the use of this carrier. Remove carrier when no

t in use.

130

Set lower clips/hooks into frame holes in bumper located by the right and left bumper strut.

131

Set lower clips/hooks into tow loop on the right and edge of bumper, by the bumper strut, on the left.

132

Thule cannot recommend the use of 3-bike carriers on this vehicle.

133

Carrier is not recommended because, lower straps can not be mounted in a safe place.

134

Carrier is not recommended because, top straps should not be mounted directly to glass or plastic trim covering glass.

135

Carrier is not recommended because, the vehicle is unable to support the weight at the point where the carrier must be place

d.

136

Carrier is not recommended because, upper arm of carrier could damage trunk lid.

137

Carrier is not recommended because, top straps can not be mounted in a safe place.

138

Lower arm of carrier will rest in the bottom of the license plate well.

139

Lower arm of carrier will rest above license plate well.

140

Lower arm of carrier will rest at bottom of trunk lip.

141

Vehicle not available at time of testing. Please call Thule at 1-800-238-2388 for update. Refer to RMS introduction page for

 carrier mounting guidelines.

142

Set lower clips/hooks on top edge of the metal bumper struts.

143

Fit requires the use of versa clip.

144

Vehicle can have an externally mounted spare tire prohibiting the use of any strap rack. Check other sections for possible f

its.

145

Set lower clips/hooks into tow loop on the left and frame hole on the right.

146

Carrier is not recommended because it cannot be installed without unwanted contact.

147

Set lower clips/hooks in to the tow loop located in the center of the vehicle behind the bumper.