Superior arched face kits sdvi Manual De Usuario

Be  sure  to  check  these  items  before  the  initial  lighting  of  the 
insert:

c

The insert gas label corresponds to the gas supply available 
- that is "natural gas" for natural gas or "LP gas" for LP gas.

c

Gas pressure has been checked carefully - see Page 13.

c

All gas fittings have been checked for leaks.

c

All clearances to combustibles have been met-see Page 9.

c

All combustible materials have been removed from the area in 

front of the insert.

c

All vented areas of the insert face are unobstructed.

c

House is ventilated to clear initial paint curing odors - see Page 

18.

c

All packaging materials have been removed from the firebox.

c

While  insert  is  cool,  fingerprints  or  other marks  have  been 

cleaned from any gold or nickel surfaces with denatured alcohol 
and a soft cloth. Marks left on these surfaces may become etched 
into the finish if not removed prior to burning the unit.

c

Log set have been installed.

c

The glass door is in place and is properly sealed.

The following is a copy of the operating and lighting instructions 
found with each insert:

A. This appliance is equipped with a piezo ignition device to light 

the  pilot.  When  lighting  the  pilot,  follow  these  instructions 
exactly.

B. BEFORE LIGHTING, smell around the appliance area for gas. 

Be sure to smell next to the floor, because some gas is heavier 
than air and will settle on the floor.

DO NOT try to light the appliance. 
DO NOT touch any electric switch,  
DO NOT use any phone in the building. Immediately call your 
gas supplier from a neighbor's phone. Follow the gas supplier's 
instructions. If you cannot reach your gas supplier, call the fire 
department.

C. Use only your hand to push in or turn the gas control knob. 

Never use any tool. If the knob will not push in or turn by hand, 
don't try to repair it, call a qualified service technician. Force or 
attempted repair may result in a fire or explosion.

D. DO NOT use this appliance if any part has been under water. 

Immediately call a qualified service technician to inspect the 
appliance and to replace any part of the control system and any 
gas control which has been under water.

1. Open the lower door. Make sure gas supply shut-off cocks are 

open and ON/OFF rocker switch is "OFF." If equipped with a 
thermostat, set it to the lowest setting.

2. Turn off all electrical power to the appliance.
3. Push in gas cock dial slightly and turn clockwise               to 

"OFF."

  Note:  Dial cannot be turned from "PILOT" to "OFF" unless dial 

4. Wait five minutes to clear out any gas. Then smell for gas, 

including near the floor. If you smell gas, STOP! Follow "B" 
above. If you don't smell gas continue.