SMC Networks robo cylinder ra4c Manual De Usuario
52
8)
Carefully insert the replacement motor unit into the cylinder by ensuring that the couplings do not lose
their alignment.
their alignment.
9)
Using an Allen wench of 2 mm across flats, tighten the two motor-unit affixing bolts on the right and
left.
left.
10) Connect a PC or teaching pendant to the controller to perform homing. (If the actuator is of absolute
encoder specification, an absolute reset must be performed).
Check for deviation from the initial home position.
If there is a deviation, adjust parameter No. 22, “Home offset” if you are using an SCON controller. If
you are using an SSEL or X-SEL controller, adjust axis-specific parameter No. 12, “Home preset.” If
your controller is of absolute encoder specification, perform homing after changing the parameter,
and then perform an absolute reset.
Check for deviation from the initial home position.
If there is a deviation, adjust parameter No. 22, “Home offset” if you are using an SCON controller. If
you are using an SSEL or X-SEL controller, adjust axis-specific parameter No. 12, “Home preset.” If
your controller is of absolute encoder specification, perform homing after changing the parameter,
and then perform an absolute reset.
2 affixing bolts on the motor-end
cap (right and left) (hexagon
socket head setscrews)
cap (right and left) (hexagon
socket head setscrews)