SMC Networks robo cylinder ra4d Manual De Usuario
25
(9) Using tapped mounting holes at the back
Applicable model: RA7 (excluding 50-mm stroke models)
The RA7 type has tapped mounting holes at the back.
Use these holes to install the actuator.
The RA7 type has tapped mounting holes at the back.
Use these holes to install the actuator.
RA7
Shown below is the maximum screw-in depth of the tapping screws used for mounting the base. Be
careful not to allow the tip of the bolt to project.
careful not to allow the tip of the bolt to project.
Type
Tapped hole diameter
Maximum screw-in depth
RA7 M5
15
mm
(10) Using T-grooves and square nuts
Applicable models: RA5C, RA5R, F5D
The RA5 and F5 types have T-grooves. Insert square nuts in these T-grooves and install the actuator
to the frame.
The RA5 and F5 types have T-grooves. Insert square nuts in these T-grooves and install the actuator
to the frame.
T-grooves
Square nuts