Polycom VSX Series Manual De Usuario

 Configuring Network Use

3 - 3

When you power on your system for the first time, the setup wizard detects 

the system’s IP and ISDN connections and leads you through the minimum 

configuration steps required to place a call. If you need more information 

about these steps, refer to the corresponding sections in this chapter. This 

guide covers network types used worldwide. Please note that not all network 

types are available in all countries.
The setup wizard allows you to set a room password, which allows you to 

limit access to the Admin Settings. The default room password is the 14-digit 

system serial number.

You can run the setup wizard or view the configuration screens in either of 

these two ways.

• In the room with the system — Use the remote control to navigate the 

screens and enter information. You can use the number pad on the remote 

control to enter text just like you can with a cell phone.

• From a remote location — Use a web browser to access VSX Web. For 

more information about using VSX Web, refer to 

 on page 

You can use VSX Web to configure all of the system settings except the remote 

management settings. These settings must be configured on the local system 

by an administrator. For more information about VSX Web, refer to 

 on page 

.

Make sure you can recall the room password if you set one. If you forget the 
password, you will have to reset the system, delete the system files, and run the 
setup wizard again in order to access the Admin Settings and reset the password. 
If Security Mode is enabled, the room password is required to access the Reset 
System screen. If you forget the room password while the system is in Security 
Mode, contact your Polycom distributor or Polycom Technical Support.