Polycom viewstation fx vs4000 Manual De Usuario

Administrator’s Guide for ViewStation EX, ViewStation FX, and VS4000

2-4

 www.polycom.com/videodocumentation

Connect an S-video cable to the camera’s S-video connector and the Camera 1 
connector on the system.

Connect a camera control cable (8-pin mini-DIN to DB-9) to the camera’s 
VISCA in connector and to the camera control 1 connector on the rear panel of 
the system.

Connect the camera’s power pack or cord to a power outlet.

If you want to connect an additional camera to your system, such as a document 
camera, see the 

 section on page 

.

If you install an original VS4000 system out of the range of the remote control (for example, 
in a separate equipment room), you will need to connect an external infrared (IR) sensor and 
place it in the conference room. To order an external IR sensor, contact your Polycom 
reseller.

The enhanced VS4000 system uses the IR sensor built into the Polycom PowerCam, and 
does not require an external IR sensor.

Connect the break-out cable to the 
PowerCam.

Connect the S-video cable to the 
system’s Camera 1 S-Video connector 
and to the 4-pin mini-DIN connector on 
the right side of the break-out cable’s 
connector block. 

Connect the VISCA cable to the 
system’s DB-9 camera control 
connector and to the 8-pin mini-DIN 
connector on the break-out cable.

Be sure the camera’s power is switched 
off.

Connect the camera’s power pack to the 
center connector on the break-out 
cable’s connector block, and to the 
appropriate power cord.

Connect the power cord to a power 
outlet.

Connect the single end of the video and 
control cable to the PowerCam.

Connect the S-video cable connector to 
an S-video to BNC adapter, and connect 
the adapter’s yellow BNC connector to 
the camera 1 C connector, and the white 
connector to the camera 1 Y connector 
on the VS4000 system’s rear panel.

Connect the camera cable’s yellow 
DB-15 connector to the camera control 1 
connector on the rear panel of the 
system.