Xyron 2500 Manual De Usuario

Long documents (such as

banners) are not aligned

with film layers after 

laminating.

Cut Blade does not slide

smoothly.

Film does not exit machine

between Upper and Lower

Blade Bars.

Cut Blade does not 

cut well.

Thin and/or wide 

documents tend to wrinkle

during lamination.

Document difficult to load.

Film wrinkles don’t go

away as crank is turned

clockwise.

Film does not lay flat, curls

and/or wrinkles.

Feed Tray not installed 

correctly or supply roll not

seated at base of groove 

in side plate(s).

Upper Blade Bar sticking in

side plate groove or blade

sticking on Blade Bar.

Material is curled or 

adhesive has been trans-

ferred to the Nip Roller

causing the film to stick.

Blade has accumulated

adhesive buildup or 

is dull.

Paddle not operated 

correctly, or tray and/or

paddle are not flat

Paddle not pulled back 

to load position or 

has adhesive buildup 

on underside.

Upper and/or lower supply

roll(s) are not firmly seated in

grooves within side plate(s).

Adhesive buildup on lower

idle bar.

Verify tray is completely

installed such that it is

approximately level and

square. Also, verify supply

rolls are completely seated

at base of grooves in 

side plate(s).

Apply silicon lubricant to all

surfaces of top blade bar.

Reposition material between

upper cut bar and lower

guide. Clean adhesive from

nip rollers if necessary.

Clean adhesive buildup

from blade using isopropyl

alcohol or Xyron Adhesive

Cleaner #990. Replace

blade if necessary.

Ensure paddle is pushed

forward completely after

document is loaded and

aligned. Ensure document

is extended approximately

1-2" (16mm) past edge of

paddle before pushing 

paddle forward. Also, check

that the leading edge of

document is evenly adhered

(“locked”) to lower supply

film by temporarily pulling

paddle back after it has

been completely pushed

forward. Check paddle

and tray for flatness.

Prior to loading document,

pull paddle back to “load”

position. Ensure underside

of paddle is clear of any

obstruction or adhesive

buildup.

Verify supply rolls are firmly

seated at base of grooves

in side plates.

Clean adhesive buildup

from idler roller using 

isopropyl alcohol or Xyron

Adhesive Cleaner #990. 

Troubleshooting

EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500