Philips fwc5-21m Manual De Usuario
12
English
Installation
Setting the clock
The time is displayed using the 12-hour clock.
1
Check the system is switched to standby mode.
(see Basic Functions, Switch on/to standby)
(see Basic Functions, Switch on/to standby)
➜
AM
12: 00 flashes by default if the clock is
not set.
2
On the system, press and hold
PROGRAM for
more than 2 seconds.
➜
The hour digits start flashing.
3
Hold down or press
4 or ¢ repeatedly to
set the hour. Release
4 or ¢ when you
have reached the correct setting.
4
Press
PROGRAM to confirm the setting.
➜
The minute digits start flashing.
5
Repeat step
3 to set the minute.
6
Press
PROGRAM to confirm the setting.
➜
The clock shows the set time.
Helpful hints:
– You may lose your clock setting when the power
cord is disconnected or power failure occurs.
cord is disconnected or power failure occurs.
Inserting batteries into the
remote control
remote control
Insert two batteries type R03 or AAA (not
supplied) into the remote control with the
correct polarity as indicated by the "
supplied) into the remote control with the
correct polarity as indicated by the "
+" and "-
" symbols inside the battery compartment.
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly.
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly.
1
2
3