Cal Flame LTR50001038 Manual De Usuario

Descargar
Página de 40
Barbecue Grills
LTR50001038, Rev. C
Installation
www.calflamebbq.com
9
Installing the Rotisserie
Attach the two brackets to the sides of the grill, one 
on each side, using two screws as shown below.
Slide  the  rotis  motor  on  one  of  the  brackets  as 
shown  below.  The  rotis  motor  will  work  on  either 
side of the grill.
Remove  the  metal  cap  protecting  the  outlet  that 
provides power for the rotis motor. Plug in the motor 
cord and screw on the retainer nut to keep the plug 
in place.
Installing Grills in Barbecue 
Islands
You will need a second person to help you to 
avoid damaging the grill, the transformer, or 
your barbecue island .
Before installing a grill or side burner in any island 
or cut out, make sure that the opening is not bigger 
than  the  outside  frame  of  the  grill  unit.    The  grill 
should  rest  on  the  lip  of  the  frame.    For  drop-in 
accessories,  adequate  cross  ventilation  must  be 
designed into enclosure to ensure the drop-in grill 
or side burner does not become overheated.
Pay  careful  attention  to  the  location  of  gas  lines.  
Gas  lines  should  be  routed  away  from  sources  of 
heat and should make as few bends as possible. 
Check to see if gas line connections will be accessible 
when grill is installed.
If gas line connections are not easily accessible 
• 
when the grill is installed, support the grill above 
counter level and attach the gas lines to the grill.  
When the gas connections are made, slide the 
grill into the cut out.
If gas line connections are accessible when the 
• 
grill is installed, slide the grill into the cut out 
and then attach the gas lines.
Be very careful not to kink gas lines when lowering 
the grill or side burner into the cut out.
Keep your fingers away from where the grill will be 
supported on counter.  Your fingers could become 
trapped and serious injury could occur.
Check to make sure the grill is level and is supported 
around the entire outside edge. If the grill is not level 
or is unstable, use non-combustible shims under the 
outside lip to stabilize it.
Perform the leak test procedure as described earlier 
in this manual.