Cal Flame LTR50001038 Manual De Usuario
Barbecue Grills
LTR50001038, Rev. C
Appendix
www.calflamebbq.com
31
Using a wrench, remove the orifice for the infrared
b.
burner.
Apply pipe compound to the fitting threads where
c.
you will place the new orifice.
Screw on the correct orifice for your grill until it is
Screw on the correct orifice for your grill until it is
d.
finger tight.
Tighten the orifice with the wrench.
Tighten the orifice with the wrench.
e.
If you have dual infrared burners, repeat the
f.
previous steps for the second burner.
Replace the back cover.
Replace the back cover.
g.
Replace the infrared burner orifices
2 .
Unscrew the back cover from the grill and lift it
a.
up and under the grill hood.
You will need:
Either a 13mm or 10mm open end wrench
•
One #50 orifice (for single infrared burner)
•
OR
Two #54 orifices (for dual infrared burners)
•
OR
One #52 orifice (for single infrared burner)
•
Pipe compound suitable for natural gas
•
You will need:
7mm wrench, socket, or nut driver
•
One or two 1.75mm orifices (depending on
•
your side burner)
Pipe compound suitable for natural gas
•
Gas Conversion (continued)
Replace the side burner orifices
3 .
Remove the grate, burner cap and burner
a.
diffuser from the side burner.
Using a 7mm wrench, remove the orifice for
b.
the burner.
Apply a small amount of pipe compound to
Apply a small amount of pipe compound to
c.
the orifice threads.
Screw in the orifice until it is finger tight.
Screw in the orifice until it is finger tight.
d.
Tighten the orifice with the 7mm wrench.
e.
If you have dual side burners, repeat the
f.
previous steps for the second burner.
Mark the rating plate
4 .
After conversion has been completed, mark the rating
After conversion has been completed, mark the rating
plate as NG with an indelible marker.