Philips MCM275 Manual De Usuario

English

Installation

Using AC power

Make sure all the connections have been made
before switching on the power supply

If your system is equipped with a Voltage
Selector, set the VOLTAGE SELECTOR to the
local power line voltage

Connect the AC power cord to the wall socket.
This switches on the power supply

When MCM275 is switched to standby, it is still
consuming some power. To disconnect the
system from the power supply completely,
remove the power plug from the wall
socket.

The type plate is located on the rear of the
set.

Warning!

To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).

Select AUX mode on the set

Helpful hints:
– Always refer to the owner’s manual of other
equipment for complete connection.

Connecting a non-USB device

It is possible to use an additional appliance, e.g.
TV, VCR or CD recorder with the set. On
MCM275, you can playback music from an
external source.

Follow the Step 1 under Connecting a USB
device or memory card

Insert one plug of the audio cable (not supplied)
to the socket AUX IN on the set ‘s foldable
control panel

Connect the other end of the audio cable to the
AUDIO OUT terminal of the additional
appliance

001-029_MCM275_98_Eng

2/17/2006, 16:20