Philips mrd120-17b Manual De Usuario
11
8239 300 30533
IMPORTANT!
If S-Video is used for DVD playback,
the system’s VIDEO OUT setting will
need to be changed accordingly.
Details are on page 25.
If S-Video is used for DVD playback,
the system’s VIDEO OUT setting will
need to be changed accordingly.
Details are on page 25.
Using S-Video jack
1
Use an S-video cable (not supplied) to
connect the DVD system’s
connect the DVD system’s
S-VIDEO
OUT jack to the S-Video input jack
(or labeled as Y / C or S-VHS) on the TV.
(or labeled as Y / C or S-VHS) on the TV.
2
To hear the TV channels through this
DVD system, use the supplied audio
cables (white / red) to connect
DVD system, use the supplied audio
cables (white / red) to connect
AUDIO
IN-TV) jacks to the corresponding
AUDIO OUT jacks on the TV.
AUDIO OUT jacks on the TV.
3
Set the
P-SCAN switch to ‘OFF.’
IMPORTANT!
If your TV only has a single Antenna In
jack (labeled as 75 ohm or RF In,) you
will need an RF modulator in order to
view DVD playback on the TV. See
your electronics retailer or contact
Magnavox for details on RF
modulator availability and operations.
If your TV only has a single Antenna In
jack (labeled as 75 ohm or RF In,) you
will need an RF modulator in order to
view DVD playback on the TV. See
your electronics retailer or contact
Magnavox for details on RF
modulator availability and operations.
Using an accessory RF modulator
1
Use the supplied composite video cable
(yellow) to connect the DVD system’s
VIDEO OUT jack to the video input
jack on the RF modulator.
(yellow) to connect the DVD system’s
VIDEO OUT jack to the video input
jack on the RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
3
Connect the Antenna or Cable TV
service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV.)
service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV.)
4
Set the
P-SCAN switch to ‘OFF.’
4
3
1
2
REAR
LEFT
SUBWOOFER
AUDIO IN
R L
R L
VIDEO
IN
TO TV
INT IN
CH3 CH4
ANT IN
3
2
1
OOFER
RF coaxial cable to TV
Option 3
Option 4
Back of RF Modulator
(example only)
Antenna or
Cable TV signal
Connections
001-037-MRD120-37-Eng
18/03/2004, 02:18 PM
11