Burley CUB Manual De Usuario

Burley Cub Owner’s Instruction and Safety Manual

Once the wheels are fully seated in the hollow axle,

the quick-relase lever should be positioned so that it is

aimed to the rear of the trailer in the “CLOSED” position

(the lever is marked for OPEN or CLOSED positions).

The wheel quick-release/axle assembly comes pread-

justed from Burley.

NOTE: All wheels, including optional spoked alloy wheels, must

be mounted with the recessed side of the hub facing out-

ward.

Make sure wheels are held securely, with wheel shaft fully

inserted into the hollow axle. You should not be able to rock or

shift wheels. Improperly installed wheels can fall off, causing an

accident or serious injury.

With wheels mounted, both refl ectors must face outward.

Check to see that both refl ectors have been installed correctly.

Incorrectly installed refl ectors can reduce visibility at night and

cause an accident or serious injury.

III. Installing the Tongue & Safety Flag

Installing the Tongue

The tongue attaches to the left side of the trailer. When installed, the tongue bends

to the right, which places the hitch near the center line of the trailer. Slide the

tongue through the two plastic tongue receptacles until the end of the

tongue is fl ush with the back edge of the rear tongue receptacle.

Secure the tongue as follows:

1. Slide the retaining pin

in the rearward receptacle through

the hole provided in the tongue.