GarrettCom 6K8 Manual De Usuario

Magnum 6K8-Series Industrial Field Switch             Installation and User Guide   (04/07) 

duplex, (2) 100Mb half-duplex, (3) 10 MB full duplex and (4) 10 MB half-duplex. 

The auto-negotiation logic will attempt to operate in descending order and will normally 

arrive at the highest order mode that both devices can support at that time. (Since auto-

negotiation is potentially an externally controlled process, the original “highest order 

mode” result can change at any time depending on network changes that may occur).  If 

the device at the other end is not an auto-negotiating device, the 6K8-Series’s RJ-45 

ports will try to detect its idle signal to determine 10 or 100 speeds, and will default to 

half-duplex at that speed per the IEEE standard. 

 

    General information - 

 -- the devices at both ends of the cable are capable of operation at either 10 

Mb or 100Mb speed and/or in full- or half-duplex mode, and can 

send/receive auto-negotiation pulses, and . . .  

 --  the second of the two connected devices is powered up*, i.e., when 

LINK is established for a port, or 

--   the LINK is re-established on a port after being lost temporarily. 

 

• 

NOTE  – Some NIC cards only auto-negotiate when the computer system 

LINK – enabled” rule above, but may be occasionally encountered. 

When operating in 100Mb half-duplex mode, cable distances and hop-counts 

may be limited within that collision domain. The Path Delay Value (PDV) bit-times must 

account for all devices and cable lengths within that domain. For Magnum 6K8-Series 

Fast Ethernet switched ports operating at 100Mb half-duplex, the bit time delay is 50BT. 

 Magnum 6K8-Series Switches incorporate a flow-control mechanism for Full-

Duplex mode. The purpose of flow-control is to reduce the risk of data loss if a long 

burst of activity causes the switch to save frames until its buffer memory is full. This is 

most likely to occur when data is moving from a 100Mb port to a 10 MB port and the 

10Mb port is unable to keep up. It can also occur when multiple 100Mb ports are 

 
 

46

.

.