Maytag mat12prs Manual De Usuario

©2003 Maytag Appliances Company

16022842  Rev. 0

29

To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

1.  Disconnect power supply to unit.
2.  Remove Front Panel.
3.  Disconnect hoses from pump.

4.  Tape washer lid to Top Cover.
5. Tilt washer and remove Pump Belt.
6. Remove three screws from bottom of base holding

pump to base.  The mounting holes for the pump on
the base frame are slotted for adjustment of the Pump
Belts.

Mark the general position of pump before

removing.

5. Remove Belts.
6. Remove three screws holding motor base to base

frame.

7. Remove Motor and Motor Base.
8. Remove Pulley from Motor.
9. Disengage tension springs and remove mounting nuts.
Note:

To remove two of the nuts, align upper and lower

sections and insert wrench through the slots into
lower section.

10.Lift  Motor Base off Motor.
Note:

With Motor removed, carriage and slides are

accessible for service.

1. Disconnect power supply to unit.
2. Remove Front Panel.

3. Remove Motor Cover.
4. Remove main wiring harness from motor terminals.
Note:

DO NOT remove the wires going from motor

switch to motor.

7. Tilt pump and lift through access hole in base frame.